my rhd conversion .... so far

[rhdboosting]

in the process of making hatch rhd ..... here are some pics of the project

here it is when i first got it....all primered

this is after i got it painted fresh white - was rocking a ls turbo set up

here she is fully stirpped

here is the firewall cut out

here is the rhd firewall

 

[revolver5446]

Sick!

 

[R3dline]

legit stuff, good work man

 

[ghost_xero]

this makes me angry.... i want to congratulate you and tear u limb from limb at the same time....

 

[SwiftEKtuner]

dayummmm Nice work dude

 

[civhatch92]

niceeeeeeee rhd ftw!

 

[Nebster66]

Rhd!!!!!!

 

[HatchmanEJ6]

AWESOME I hope this gets finished. keep us updated

 

[98civb18c]

mad props for DIY RHD. I'd just say f**k it and spend money somewhere else and look ballin in a LHD.

 

[Young gunna]

lookin sick dude!

 

[Claire09]

man that looks SICK...where did u get the firewall from and around how much?

 

[L.D.Forget]

man that looks SICK...where did u get the firewall from and around how much?

x2

 

[rhdboosting]

thans for the props everyone. i found it browsing around on a few different honda websites. it cost 800 for the whole front half of the car, well minus a motor. I also went and picked it up myself from MA, so from NJ it was roughly a 4 hours ride. Tolls and gas there and back weren't that bad either, but it was a long ride. The kid I got it off of said he bought a few rhd clips from a factory in PA (which i believe he said was going out of business, but not sure lol)

 

[somejaykid]

very nice keep us updated op

 

[DirtyJerrz84]

We had alot of fun in her and even more to come!

After swapping the green wheels to white

Gotta rep the shop name lol

 

[Hecz]

damn, thats crazy. when you weld the fire wall on, how hard is that part? im sure you cant just hold it up and weld, i assume it's gotta have some alignment to match up?

 

[ImportFan1]

Nice progress. Keep up the good work.

 

[rhdboosting]

damn, thats crazy. when you weld the fire wall on, how hard is that part? im sure you cant just hold it up and weld, i assume it's gotta have some alignment to match up?

i cut out the firewall as close as i could and it matched up almost perfect, but in some spots there is more of a gap then in others. i should have it welded this week. i know the right way is to drill out all the spot welds, which i started to do, but then just decided to cut my firewall out and then cut the rhd one out. then i trimmed it down till it slid in place. i have a few more pics from today, but i have to upload them still

 

[sincivic_vx]

Dude that looks great... will you do mine? lol j/k

 

[98 EK Hatch]

nice s**t man.... i hope you think its worth all the work once your done with it lol