endo617's 98 Civic LX Project: Balance

[endo617]

Only thing missing is the parts of my current motor (throttle body, flywheel, clutch, thermostat housing and cam gears.)

 

[endo617]

Unearthing my 91 Si Turbo project. It's about to get funds soon, cant wait to start it back up.

 

[endo617]

Engines out, swapping the parts is taking longer than intended. Snapped a bolt on the flywheel pressure plate!!!!!!!!!!!!!!!!! I might have a solution. I'll keep you guys posted.

 

[endo617]

Engines in and running. Need to figure out the low idle, might just be a ground issues. Besides that the torque is nice.

 

[endo617]

Pics from the Sept. 28 I forgot to post, 2nd place in class that day.

 

[endo617]

Event 8, pretty bad times. GSR transmission and B20b redline are not good for AX. Fuel cut tapping all over the place. Got 5th place but good news 3rd Place overall for the year

Awesome pics

 

[endo617]

In case any ones curious, this is where I race. It's not a small parking lot

Google pic has people racing
https://www.google.com/maps/place/42°34'19.8"N+71°36'20.0"W/@42.5732893,-71.6052519,770m/data=!3m1!1e3!4m2!3m1!1s0x0:0x0

 

[jameswanser]

Unearthing my 91 Si Turbo project. It's about to get funds soon, cant wait to start it back up.

HOLY CRAP! There was a car under there?!?

 

[endo617]

HOLY CRAP! There was a car under there?!?

Yup Im going to add the project to this build thread.

 

[endo617]

Fixed my idle issues, faulty tps and sketchy IACV. Picked up a Fidanza for $40, just need to buy a replacement insert and im good.

 

[endo617]

After some research ordered these bulbs. They are supposed to be the best OE replacement.

 

[ghostz32]

I like that rear mugen skirting

 

[endo617]

Finally after searching through forums and sites I fixed my idle problem. Went through a ECT, IACV, ECU and TPS. The culprit was a faulty o2 sensor. I was being masked by my chipped ECU. Got myself a P75 and then the car idled correctly but bogged horribly when driving.

Here's the bucket B20, plans for a 1.9ish GSR rebuild of my old engine for next season. Need to start collecting parts already have an LS crank.

 

[endo617]

Got some freebies, New NGK Non vtec wires(Don't mind the the 4th wire I have it) and a Edelbrock Fuel Rail.

 

[endo617]

I'm tire of those s***ty distributor rotor screw so I fixed it.

Home Depot M5x12 Hex Bolt, Split Washer and Zinc Washer

These screwdrivers are awesome to handle these bolts.

This piece needs to be trimmed on the inside with some wire cutters.

You'll done no more hard to remove phillips screw

 

[endo617]

Got myself a Christmas present.

 

[endo617]

Suspension parts for next season are being collected.

 

[endo617]

Can't wait, picking them up this weekend.

 

[endo617]

Picked them today, they are perfect. Super light, and solid. Test fittin tomorrow.

 

[Bhikku]

Got myself a Christmas present.

those mats are sick