3 Bar map sensor?
- Thread starter Sleeper
- Start date
no it will not. both sensors use the same voltage range- 0-5 volts, however because the stock map is 1.75 bar and the gm is 3 bar, the voltage output is not identical, and as such, needs a controller to allow the ecu to correctly read the voltage. you need uberdata, vafc, or other map sensor controller.
The Grim Sleeper said:
supposedly. ive never used a vafc nor would i ever, however i have heard of people running wider map sensors with a vafc.
I have a 5-6psi setup right now, & I need to rid of the CEL for now, I will be gradually raising the boost 10+ as I work the qinks & bugs out such as the map senso & fuel managment so a missing link isnt going to cut it for the amout of boost I plan on runnning in the very near futureio_303 said:
where about can I get more information on running a 3bar with a VAFC hack, I didnt want to go anywhere near going with a hack, but for right now I need something asap & I can get my hands on a vafc anytime. I dont have a chip burner for uberdata nor can I afford hondatahandlebarsfsr said:
www.pgmfi.org will have all the info you need. You can get a chip burner for $50 from xenocron.com
i think www.homemadeturbo.com has a howto on the AFC hack
run uberdata grim. its the best bet. mike has been burning my chips for me too 
: wrong thread...