Hey guys I don't know if any of you could help me but earlier today I got bored and swapped out the rpm cluster 8k to the 9k one. After I installed it and turned the motor on I noticed the needle wasn't where it should be. Like before I put it in my car would idle around 500-800rpm or so. But now the needle read 1.5. And when I drive let's say 4th gear normally when going around 55-60mph the tach would be around 4.5 but now it would only be around 2.5rpm. So I guess my question is how do you adjust it to where its suppose to be? Did I mess up my cluster?
Sent From EVO LTE
Sent From EVO LTE