Does anyone know the dremel size needed to bore the injector rings on dsm

[EF Honda EF]

so yea i was wondering if anyone knew the size dremel to bore out the injector rings so my dsm injectors fit. I have been to home made turbo and a few other sites and they just say get a dremel but i dont want to mess anything up so having the right size would be a plus

 

[Steven.]

the standard one, the one that comes with teh kits.

i belive its just the sanding disk.

 

[Phantom Civic]

You can use a pocket knife if your careful.

 

[Evan.]

I just bored them until they fit around the injectors and into the manifold. Obviously, I used a smaller disk so that Id error on the side of being too small.

 

[slowhatch]

i put a little bit of lithium grease on the injector and seal ring then pressed them in, no shaving required. dont use too much like i did my first time cuz it gunks up the injector.

 

[fsteclipsegst]

i put a little bit of lithium grease on the injector and seal ring then pressed them in, no shaving required. dont use too much like i did my first time cuz it gunks up the injector.

word