Drilling holes in gas pedal...

[seang]

I got some sparco racing pedals and they require drilling holes in the pedals well the clutch and brake pedal I already did just fine-took the pads off and drilled the holes but the gas pedal rubber does not come off and I don't know if there are any caveats to drilling holes in the gas pedal cause of throttle by wire or whatever. I know this seems trivial I just don't want to screw my car up by doin somethin stupid ya help will be appreciated-thanks!!!

 

[speedygonzales]

its a 5th Gen man... its just a hunk of metal with a rubber cover. drill to your hearts content. also just a side note I think the first time Honda used the drive by wire set up was in the s2k so you're fine as far as that is concerned

 

[lethal6]

Since you are posting in the 5th gen section I am assuming you are working on a 5th gen. The pedal is plastic to my knowledge. There is no rubber cover...at least there wasn't on mine.

 

[seang]

Thanks a lot I'll get to drilling...

And complete my project- thanks guys!!!

 

[seang]

Job complete!!!

Thanks 4 the feedback everybody job complete after a year but complete nonetheless.

 

[mymmeryloss]

Pics?