Quick Facts -
I had a trade lined up. The trade fell through. I would still like to trade this entire project over into someone elses hands.
At the bottom of this thread, I have listed the cars I am interested in. If you have something else to offer, still feel free to pm me.
Basically, I'm looking for someone to take this project and finish it. So make me a reasonable offer and everything you need to finish it is yours!!!! I realize I'm not going to make all my money back, so don't be afraid to make an offer, I'm sure I'll go lower than most would assume...
Thanks!
Ok, brief story:
I purchased this car as the second owner in early 2004. By the end of the year we had completed the h22a swap with some minimal mods. In June of 2005, I had all the exterior mods completed. Late '05 the car is put away for the winter and in April 2006, I decided to redo the motor as well as a few other things that bothered me. Since then, the car has been on jackstands, as you'll see in the pics to follow.
- Since I have owned it, this car has never seen rain or snow.
- Always stored in a garage.
- This was NOT my Daily Driver and was only driven on some weekends. And when it was driven, it was only for a couple hours.
Here's some pics of how it looked put together, as well as some more recent pics:
All the rest of the build can be found here:
http://www.clubcivic.com/board/showthread.php?t=89156
__________________________________
Here's a list of all the mods + parts:
ENGINE:
JDM H22a - Stock Bore
Bottom end - blueprint, etc. ( I have a receipt somewhere with everything done to it )
Wiseco 8.5:1 Pistons
Darton Sleeves
Crower I Forged Rods
Head-
Crower Valve Springs + Retainers
Crower Turbo Cams
P&P
ARP Head Studs
Cometic Head Gasket
Hondata s200b w/ p28 ECU
Hondata Intake Manifold Gasket
Garrett Gt3582r
PeakBoost Manifold
PeakBoost Downpipe
PeakBoost Dumptube
Vibrant Muffler
Vibrant Intercooler
All i/c piping
Tial 38mm Wastegate w/ 1 Bar Spring
Blitz BOV
STR Fuel Rail
Greddy Timing Belt
Greddy Balancer Belt
Walbro 255 Fuel Pump
ACT Clutch
ACT 12 lbs. Flywheel
HCP Motor Mounts + Crossbar
DSS Stage 1 Axles w/ intermediate shaft
780cc Injectors
JDM Oil Cap
Jaz fuel cell - 16 gallon
Also, in the engine bay, we did some shaving of holes,
and we were planning out a wire tuck as well...
INTERIOR MODS:
JDM ITR Recaros
JDM EK4 Gauge Cluster
JDM/EDM Clock
JDM CTR Shift Boot
CDM Air Bag Tray
OEM Honda DIN Block Off
Custom Carbon Fiber Sheet - ( Was going to be used to
house the gauges )
MOMO Hub Adaptor - Don't have the MOMO wheel anymore,
but you could still get one )
R.J.S. Racing Harnesses
Auto Power 4pt Roll Bar
Defi BF Imperial Gauges ( Boost, EGT, Oil Pressure )
Defi Link Meter
Blitz Dual SBC Spec S w/ Custom Red LEDs
JDM Broadway Mirror
Painted Black
Tucked wires
EXTERIOR MODS:
Phoenix Yellow Paint w/ Black Roof
99/00 OEM Honda Front End Conversion
JDM CTR Side Markers
JDM Raybrig Yellow Fogs
JDM Raybrig Rear fog
OEM Honda License Plate Plugs
VIS OEM Style Carbon Fiber Hood
VIS Carbon Fiber M Style Lip
Spoon Style Carbon Fiber Mirrors
Shaved Antenna
Shaved Side Moldings
WHEELS / SUSPENSION:
Black Racing N1 Wheels w/ Custom Color Matched Lip
Hankook Ventus R-S2 Z212 205/45/16 Tires
GSR Front + Rear Brakes
Ksport Full Coilovers
Skunk2 Extended Wheel Studs
Skunk2 Extended Lug Nuts
I'm sure I missed some thigns here and there, in addition to all brand new OEM gaskets, etc.
* I also have ALL the oem parts - including, but not limited to the interior, engine and exterior.
________________________________________
Now, the reason I am selling/trading:
I have lost my work area, have no tools and need this gone. So I'm looking for something I can just get in a drive.
Keep in mind the car is NOT together. But, I literally have EVERY SINGLE part you will need to put this thing back together. I did sell a few items, so if you're really interested I'll let you know what they were.
______________________________________________
Now as far as the trades go here's what I'm looking for:
* 2002-2003 WRX *
I'm also open to 04-05 wrx or sti's or a 2002+ Lexus IS300. Or if you want to make an offer on everything, I'm open to that as well.
When it comes down to the trade, depending on what you have, we can figure out cash, what parts you or I may want to keep, etc. I'm also willing to travel ( to an extent ) and even ship this car.
______________________________________________________
Please let me know if you are interested through these contacts:
* This thread
* Pm me
* E-mail me at Jezekracing@yahoo.com
Thanks for checking it out, I realize I have to find the right buyer for this, so spread the word!!
_________________________________________________________
$13,000 o.b.o cash takes EVERYTHING
...Just buy it and put it together to run 10's all day...
I had a trade lined up. The trade fell through. I would still like to trade this entire project over into someone elses hands.
At the bottom of this thread, I have listed the cars I am interested in. If you have something else to offer, still feel free to pm me.
Basically, I'm looking for someone to take this project and finish it. So make me a reasonable offer and everything you need to finish it is yours!!!! I realize I'm not going to make all my money back, so don't be afraid to make an offer, I'm sure I'll go lower than most would assume...
Thanks!
Ok, brief story:
I purchased this car as the second owner in early 2004. By the end of the year we had completed the h22a swap with some minimal mods. In June of 2005, I had all the exterior mods completed. Late '05 the car is put away for the winter and in April 2006, I decided to redo the motor as well as a few other things that bothered me. Since then, the car has been on jackstands, as you'll see in the pics to follow.
- Since I have owned it, this car has never seen rain or snow.
- Always stored in a garage.
- This was NOT my Daily Driver and was only driven on some weekends. And when it was driven, it was only for a couple hours.
Here's some pics of how it looked put together, as well as some more recent pics:
All the rest of the build can be found here:
http://www.clubcivic.com/board/showthread.php?t=89156
__________________________________
Here's a list of all the mods + parts:
ENGINE:
JDM H22a - Stock Bore
Bottom end - blueprint, etc. ( I have a receipt somewhere with everything done to it )
Wiseco 8.5:1 Pistons
Darton Sleeves
Crower I Forged Rods
Head-
Crower Valve Springs + Retainers
Crower Turbo Cams
P&P
ARP Head Studs
Cometic Head Gasket
Hondata s200b w/ p28 ECU
Hondata Intake Manifold Gasket
Garrett Gt3582r
PeakBoost Manifold
PeakBoost Downpipe
PeakBoost Dumptube
Vibrant Muffler
Vibrant Intercooler
All i/c piping
Tial 38mm Wastegate w/ 1 Bar Spring
Blitz BOV
STR Fuel Rail
Greddy Timing Belt
Greddy Balancer Belt
Walbro 255 Fuel Pump
ACT Clutch
ACT 12 lbs. Flywheel
HCP Motor Mounts + Crossbar
DSS Stage 1 Axles w/ intermediate shaft
780cc Injectors
JDM Oil Cap
Jaz fuel cell - 16 gallon
Also, in the engine bay, we did some shaving of holes,
and we were planning out a wire tuck as well...
INTERIOR MODS:
JDM ITR Recaros
JDM EK4 Gauge Cluster
JDM/EDM Clock
JDM CTR Shift Boot
CDM Air Bag Tray
OEM Honda DIN Block Off
Custom Carbon Fiber Sheet - ( Was going to be used to
house the gauges )
MOMO Hub Adaptor - Don't have the MOMO wheel anymore,
but you could still get one )
R.J.S. Racing Harnesses
Auto Power 4pt Roll Bar
Defi BF Imperial Gauges ( Boost, EGT, Oil Pressure )
Defi Link Meter
Blitz Dual SBC Spec S w/ Custom Red LEDs
JDM Broadway Mirror
Painted Black
Tucked wires
EXTERIOR MODS:
Phoenix Yellow Paint w/ Black Roof
99/00 OEM Honda Front End Conversion
JDM CTR Side Markers
JDM Raybrig Yellow Fogs
JDM Raybrig Rear fog
OEM Honda License Plate Plugs
VIS OEM Style Carbon Fiber Hood
VIS Carbon Fiber M Style Lip
Spoon Style Carbon Fiber Mirrors
Shaved Antenna
Shaved Side Moldings
WHEELS / SUSPENSION:
Black Racing N1 Wheels w/ Custom Color Matched Lip
Hankook Ventus R-S2 Z212 205/45/16 Tires
GSR Front + Rear Brakes
Ksport Full Coilovers
Skunk2 Extended Wheel Studs
Skunk2 Extended Lug Nuts
I'm sure I missed some thigns here and there, in addition to all brand new OEM gaskets, etc.
* I also have ALL the oem parts - including, but not limited to the interior, engine and exterior.
________________________________________
Now, the reason I am selling/trading:
I have lost my work area, have no tools and need this gone. So I'm looking for something I can just get in a drive.
Keep in mind the car is NOT together. But, I literally have EVERY SINGLE part you will need to put this thing back together. I did sell a few items, so if you're really interested I'll let you know what they were.
______________________________________________
Now as far as the trades go here's what I'm looking for:
* 2002-2003 WRX *
I'm also open to 04-05 wrx or sti's or a 2002+ Lexus IS300. Or if you want to make an offer on everything, I'm open to that as well.
When it comes down to the trade, depending on what you have, we can figure out cash, what parts you or I may want to keep, etc. I'm also willing to travel ( to an extent ) and even ship this car.
______________________________________________________
Please let me know if you are interested through these contacts:
* This thread
* Pm me
* E-mail me at Jezekracing@yahoo.com
Thanks for checking it out, I realize I have to find the right buyer for this, so spread the word!!
_________________________________________________________
$13,000 o.b.o cash takes EVERYTHING
...Just buy it and put it together to run 10's all day...
