Help Me

[Sivtc99101]

I have a built b16 w/o sleeves just block guard, pistons, rods, knifed crank, complete valvetrain, Vortech FMU, cometic gasket, port polish, deck and blueprinted.
I had a vortech s/c but it was stolen off the car. Going turbo now and want the peak boost set up with the .64a/r 57 trim. Please help as to places to buy everything I need were it may be cheaper. I have a total of 3000 to spend. Thank you for your time...

 

[xNOBOOSTx]

check out homemadeturbo.com , they have some good info on there.

 

[mike@synapse]

i would ditch that fmu if you want your motor to last. an fmu is not a proper tuning solution. i would get hondata or neptune if there is a dealer near you, as well as properly sized injectors for your power goals.

pm sent

 

[Phantom Civic]

A built motor and a fmu? Why? You still shouldn't go over 6psi...