caribboy10
New Member
hey guys thanks for reading.
So i bought a freshly rebuilt z6 head off of a buddy of mine and was wanting to swap it onto my y7 bottom end.
Now heres the thing i was wanting to run a slightly higher compression ration without having to deck/mill the head. Im not sure what would be the best piston options for this at all.
Im planning on using the z6 cam gear and a felpro 2 piece head gasket from a y8.
Also i have a y8 intake mani that im planing on using.
And the only other question i have is can i gut my y7 dizzy and put that into the z6 dizzy?
thanks for reading and the advice in advance.
So i bought a freshly rebuilt z6 head off of a buddy of mine and was wanting to swap it onto my y7 bottom end.
Now heres the thing i was wanting to run a slightly higher compression ration without having to deck/mill the head. Im not sure what would be the best piston options for this at all.
Im planning on using the z6 cam gear and a felpro 2 piece head gasket from a y8.
Also i have a y8 intake mani that im planing on using.
And the only other question i have is can i gut my y7 dizzy and put that into the z6 dizzy?
thanks for reading and the advice in advance.