Installation help

CivicDippin

New Member
5+ Year Member
So i am putting in subs in my 98 and i have one problem. Were am i suppose to run the amp wire? I couldnt find any hole so im reall stuck now. It doesnt fit through the door and i thouhgt about drilling a hole but havent dne it yet. So any suggestions would help.
 

Genuine Rolla

Its PETEY PETE, y0!
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
15+ Year Member
There should be a lil grommet that you'll see by the firewall...that is a lil bit below the battery and to the right. Thats where I run all of my wires. Let me know if you need me to take a pic for you today.
 


B16EKHatch

New Member
5+ Year Member
yep thats where my 4 gauge is ran through. take out the grommet and slice the grommet in the middle into like a star shape but dont cut a hole out of it so now water wont leak through.
 

CivicDippin

New Member
5+ Year Member
kool thanks for the spot. Would it be posible to see some pictures of that just for refrence. Were does that come outin the car too. Like were the passanger seat is or what. Thnaks for the help guys
 


Matt.

Banned
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
are you guys talking about the grommet the wires for the ecu go through? I think that would be a better place to put the wires through. Much easier, just remove the battery and you'll see it.
 

CivicDippin

New Member
5+ Year Member
I saw that spot and it looked way to difficult to get your hand in the glove box area to reach there. Just seemed hard but thats not the spot were talking about.
 

JohnS.

BANGARANG
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
15+ Year Member
All I know is there is a little rubber grommet piece directly behind and a few inches under the bottom of the battery. Poke a few holes, use needle nose pliers, and jam that b***h through. I've ran a few wires through there.
 


Top