LM-1 Stock replacement O2

[AllTracCelica]

Hey guys,

I need to know how to wire in the LM-1 Wideband sensor to HONDATA s300? I have been looking all over and cannot find a guide on how to wire this to replace stock O2.


Please let me know thanks.

 

[AllTracCelica]

anyone?

 

[2NRSTV]

What ECU are you doing this to?
I'm not sure, but I think I've only seen Hondata S300's used with PLX's.
I hear the LC-1's and LM-1's have issues with the S300.

Edit: As far as I know, you plug one analog output to the stock 02 input and the other into the wideband input. Then run the the serial cable and set the parameters to have one as stock narrowband and the other to wideband. I'm not sure if this is true for the LM-1's, but that's what my friend was telling me. I'd rather go with the PLX.

 

[AllTracCelica]

Yeah but i already have a LM-1. Do you know what wires to what to hook it up? And does the wires need to run through my wideband controller or can the ECU control it completely?

 

[2NRSTV]

I think I found what you are looking for.

http://www.spdweb.net/knowledge-base/70/111-wiring-the-innovate-lm-1-to-obd1-ecu

 

[AllTracCelica]

bingo exactly what i wanted!