Manual Boost Controller issue

[jr_fb6]

I am trying to finish my turbo build.... My turbo is a eBay turbo without the pressure port on the intake side. I can't find out how to run my manual boost controller (mbc) without the pressure port. WTF can I do... oh btw I have a vacuum manifold block. Not sure if that will work. PLEASE SOMEONE HELP... Thanks

Sent from my SM-N920T using Tapatalk

 

[A]]Th!ngSound]

You need to tap the turbo for boost reference. Some people tap their intercooler piping, but I'd tap the turbo. Read this: http://www.d-series.org/forums/diy-forum/115393-diy-tapping-your-compressor-housing.html

MAKE SURE TO TAKE THE HOUSING OFF WHEN YOU DO THIS. You don't want metal shavings or any other foreign material to make its way into your engine. Clean up with carb cleaner and blow it out really good when you're done.

Here's a diagram of typical vacuum line set-up on a Honda with a manual boost controller: http://www.d-series.org/forums/attachments/forced-induction/27248d1300671636-vac-boost-diagram-turbo-set-up-diagram.jpg

 

[jr_fb6]

Thank you I pretty much did it exactly how the diagram said . Works perfectly thanks for the help and the diagram

Sent from my SM-N920T using Tapatalk