My '94 Civic DX Hatchback

[Trev86]

Hello Club Civic, Im a New member here and recently purchased my civic, so I figured I'd show it to you all and see what you thought

Cold air intake added, Engine swapped for a 96civic with 30,000kms, front and rear headlights changed, exhaust, tint, Pioneer deck, MTX Sub

 

[donovan772]

Looks like an okay start, but may I suggest you change the tail lights and headlights back to oem, also some smaller wheels(15's or 16's) and a drop. Just some suggestions.

 

[R3dline]

clean car, but it does need smaller wheels, differnt corner lights and tails tho. good luck with it man

 

[yamaharider324]

I actually like those corner lights but I do agree with everyone else, some smaller rims and tails and you are off to a good start.

 

[Robin...]

Needs tails, corners, and smaller wheels... Other than that, its all good...

 

[Trev86]

I agree with the lights, at least the tail lights. When I bought the car it already had the lights it has now, but I also got the stock lights too, so im gonna put the stock tail lights back, and I would drop it, but My driveway is on an extreme vertical incline, so if my car were any lower, it would hit the muffler and s**t when going up the driveway, thats why it helps that I have the bigger rims too, cause it has added height.

 

[CDubs]

looks good man, i kind of like the corner lights, lose the tails and smaller wheels, i hear you on that driveway deal, mines all messed up from the street rotting away and s**t, but i put some plywood down so when i scrape its on that, anyway good luck with it

 

[aeaddy03]

very nice eg hatch bro! i would reconsider the tail lights but other than that i like the look of it. whats your plans?

 

[donovan772]

I agree with the lights, at least the tail lights. When I bought the car it already had the lights it has now, but I also got the stock lights too, so im gonna put the stock tail lights back, and I would drop it, but My driveway is on an extreme vertical incline, so if my car were any lower, it would hit the muffler and s**t when going up the driveway, thats why it helps that I have the bigger rims too, cause it has added height.

Man my EM1 is lowered and I do fine and I have like 4-5 inch speed bumps I go over. And my drive way is weird too. You just gotta angle it right.

 

[95 lsvetec]

any motor work done to it?

 

[grumpz]

any motor work done to it?

x2

 

[civicfan111]

I agree with every1 else.. Any way, welcome to the sight..
I'm assuming u mean a d16y8? Or is it another single cam non v motor?

 

[Trev86]

I'm actually not sure whether it's a dx or a cx, the add I bought it from had it listed as a dx, but when I went to get it registered, they said it was a cx. Also, the head gasket on the original engine blew, so that's why I'm getting it replaced

 

[AMF]

its a DX .... CX's does'nt have side moldings.... but it looks pretty solid thoe.... great find!!

 

[Nebster66]

BUMP for a fellow Canadian member!
Dude, just lower it with either coilovers or lowering springs.
Get some smaller rims and headlights and corners are fine, but the tail lights DON'T pass! lol

Keep up the good work!