Need Dyno For a DX
- Thread starter Jeff1119
- Start date
Less than that because the dyno measure's wheel horse power, whereas your factory horse power rating is taken from the crank.
A stock d15 probably puts out around 80 hp at the wheels. It will put out even less torque.
A stock d15 probably puts out around 80 hp at the wheels. It will put out even less torque.
DX raceR, ignore VtecThis. Since you're only 5 posts into this I'm sure you haven't seen what else he's said. Trust me, he's not the one to listen to about anything.
Everyone, go to the specs section and look up the motor. Those specs are at the crank. Then subtract somewhere between 10% and 20%... Probably closer to 10% seeing as how the car is FWD. That should give you a rough estimate of your wheel horsepower.
Everyone, go to the specs section and look up the motor. Those specs are at the crank. Then subtract somewhere between 10% and 20%... Probably closer to 10% seeing as how the car is FWD. That should give you a rough estimate of your wheel horsepower.
my gtech measured 94whp. my wieght wasnt dead-on, so its not completly accurate, but it cant be too far off. but theoretically, should be around 90whp for a manual.
http://aempower.com/default.asp
Click on the
"AEM V2 INTERACTIVE PRODUCT DEMONSTRATION"
when the new page loads,
click > Performance>then>Dyno graphs
Click on the
"AEM V2 INTERACTIVE PRODUCT DEMONSTRATION"
when the new page loads,
click > Performance>then>Dyno graphs