Problem Very Confusing!!plz Help Asap

[PureLogic]

ok heres the deal i have a kenwood 1000 watt amp it works fine when i test it but when i actually hook it up to my subs and have all the wires connected it dont work....... i checked everything but it still dont work.... i used a speaker wire to connect my rmt wire to the blue wire inside the deck was that a good idea or did i do it wrong???? maybe its my rmt wire? or my ground? where is a good place to hook up my ground wire?? i have a 2003 honda civic lx sedan my amp is in the trunk and i dont know where to hook up my ground wire.....but anyways rmt wire is blue rite??? oh and another thing my amps has two GRND slots not one but two should i ground both of them or just one??? anyways plz help me get my amp to work...thanx

 

[Handlebars]

9 times out of 10, system problems are caused by either bad grounds or bad fuses. check both.

 

[J32a2OwnsU]

I dont know if the guage of the speaker wire is too thick.......

I ground mine to the frame (when the amp is in the trunk anyway)

Read the manual for wire description.... i dont know them off the top of my head...

 

[B Rich 157]

I got one of those amps myself. Only one needs to be hooked up. You just need the one with your rmt wire next to it. And like everybody else said, it's probably where you got your wire grounded. if it has body paint on the metal up under the screw you got it grounded to, then you need to scrape the paint off under the screw with a screw driver or something.

 

[[civic]]

You can use any wire for the remote so that isnt the problem. Change the grounding point to another. Make sure your 12+ wire is the same gauge as the -Grd Wire.

If you can figure out that you are getting power from the wires and the amp doesnt turn on, the amp may be busted. Do you have an amp kit? Maybe you have a blown inline fuse.

 

[PureLogic]

ok i checked all of those and the fuse are all good but the rmt wire wont turn the amp on i know all the other wires work because when i run my other amp direct it works but when i dont run it direct the amp dont work....... the amp is not busted because i tested it thru direct.........is there another wire besides the blue one where i can connect the rmt wire???

 

[Handlebars]

there should be a wire specifically for remote. if not, use the wire for the power antenna.

 

[PureLogic]

there are two blue wires a light blue one and a dark blue one....i hook it up to both and still dont work then i hooked it up to my power outlet and walla it worked the power outlet is where u plug in your cell or w.e