Sub and amp trouble...

[dth0ng69]

okay i have 2 JL 12' W3v2 in a sealed box. My amp is Pioneer GM-5200T. http://www.amamax.com/picaramgm76m.html
My subs are dual voice coil and are wired in series, Also my amp is bridged to connect to my subs

Here is the problem, there was a whole bunch of wiring issues that i had to deal with within these past few month, and i finally got everything connected without any problems, but i didnt replace any wiring.
Then when i was listening to my music out of no where my subs cut out. I checked my amp and the power is on, i checked all the wiring and its fine.

My prediction is that its either my RCA cables or The wiring of the Subs in the box.
because my amp is on, but the subs just don't work.

what do you guys think? or what is the common problem if the subs don't work and the amp is on?

I know my amp is weak and im looking to replace it soon because sometimes they work and sometimes they don't work as good its weird.

 

[quescivic]

HI dth0ng69

Do this disconnect your amp from your subs. Since you have a seal box your wiring (subs) inside your sealed box might be wrong. Try this take one sub and wire the + and - to the + and - connector that is located on the back of your sealed box. Do the same thing with the other sub. Now each sub should connected to the connector that located on the back of your sealed box. Since you have dual voice coil not a problem.... Now you should have a + and - on each sub unused, right!!!! Take one sub and connect the unused + and- to the other side of that sub + and -. Do the other sub the same way. Take the (L) side
of the amp + and- to the (L) side of the connector + and - on the back of the sealed box. Repeat it on the (R) side of the amp + and -. Now thunp your sounds, that should work. Let me know if that solved your problem.

quescivic