Throttle sticking just a little bit. AGGRAVATING!!

[logancfuller]

Hello, hoping somebody can help. My 96 civic needed a map sensor because it was cracked and also the throttle body was cracked where the map screws in. So I got a nice looking throttle body from my local upull. I put the new one on and now when I barely touch the gas it will stick at what sounds like 1500 maybe 2000 rpm. But I can put my foot under the pedal and it will go down to normal idle. Its something to do with this throttle body because I put the old one back on just to check and it idles correctly. I have cleaned almost every inch of this thing. Any suggestions?

I also to the idle control sensor from the old one and put on the new one

 

[young_]

Have you checked your throttle cable?

 

[XpL0d3r]

Clean the throttle plate with brake cleaner too, it might be sticking.

 

[logancfuller]

Yeah I got my cable right and just to double check I put the old throttle body back on and everything worked right. Its something to do with the t body. I cleaned my plate pretty good but I can feel it stick a little when I push it open. But the old one does the same thing. Should I put my old plate in the new tbody?