i just got my rubicon soundstream in and i install it and it make this whinning noise like eeeeeeeeeeand when i rev u hear it too. when i had one amo hooked up i didnt have this problem. but i am tryingto hook up 2 amps for my highs and my lows.
whats that whinning noise?
- Thread starter slamDunk
- Start date
your power to your amps is sending off signals from the engine and interfereing with ur RCA's most likely. try to separate them or cover the RCA's in aluminium foil to reflect the signals
your best bet would be to re-run the wires on the opposite side of the car from the power wire, but if you dont feel like doing that (i didnt) you can just wrap the RCA wires with the foil from the radio to the amp or however much you want to. I know this is prolly a really ghetto way to do it, but it worked for me juuuust fine
update: ok i rewired the rca to the oppisite side of the power wire,but the noise till didnt stop.but on the back of the deck and i have 2 rca inputs front & sub inputs. i plug my rca in the front input and i had to cover the back of the sub input with foil and had to tape it down with duck tape. thanks hondaspeedx
frame/chassisslamDunk said:where would be a good place to ground?
that should be a good placeslamDunk said:chaisis u mean the rear strut bolt on top?