Yeah I purchased a wiring conversion harness from Hasport for my H22 swap into my accord. They sent me the engine harness wired up and ready to got, also got one seperate connector which i assume plugs into the harness on the car side...
Here are they're instructions:
Plug the ECU pins into these positions,
Green/Yellow (Vtec Selenoid) 18 gauge wire to A4
Blue/Red (knock sensor) 20 gauge wire to D3
Blue/black (vtec oil pressure 20 gauge wire to D6
Red (IAB) to A17
ok, now the connector has the Blue/red and red wires on it where do I take the other two wires from to plug into A4 and D6?
kinda lost here?
They only sent me one plug, am I missing one?
Here are they're instructions:
Plug the ECU pins into these positions,
Green/Yellow (Vtec Selenoid) 18 gauge wire to A4
Blue/Red (knock sensor) 20 gauge wire to D3
Blue/black (vtec oil pressure 20 gauge wire to D6
Red (IAB) to A17
ok, now the connector has the Blue/red and red wires on it where do I take the other two wires from to plug into A4 and D6?
kinda lost here?
They only sent me one plug, am I missing one?
