i know how to run the piping and stuff but where do all the oil lines and other lines go? If anyone has a diagram that would help. thanks guys
Need help with turbo install
- Thread starter Jdm_civic_ek2
- Start date
smaller line, usually on top of the turbo is the oil feed line, you can get a sandwich plate for your oil filter or get the stealth mode kit and run it from your pressure sensor. The lower bigger line is your oil return line, it goes back to the oil pan. Normally you want to make sure the oil return line is as high up on the oil pan as it could possibly go.
so what about the lines from the bov and is there any cooling lines?
cooling lines are usually only on stock turbo cars.
The bov and waste gate are run off vacuum lines.
what about getting one of those vaccum adapters for turbo
and on the turbo i know where the oil lines go but then there are two other tapped holes by the oil line holes. What are those for?
coolant
so do i have to hook up the coolant lines then and if so where?
what turbo...sounds like a stock DSM turbo to me... that would help...
its out of a mistubishi starion T05-12
and i also can't find gaskets. Any ideas?
This is what i got going on.
what is the easiest way to use this manifold with this turbo
what is the easiest way to use this manifold with this turbo
yep
and this will work?
you bet^
ok and as far as the coolant holes on the turbo what do i do with these, do i block them off or what?
In the picture of the turbo i posted up there its the silver fittings.
In the picture of the turbo i posted up there its the silver fittings.