wiring subs

[Pathos]

I have a RF p6001 mono channel amp, and 2 12" Alpine type E's.

What would be the best way to wire them?

 

[ScratchNSniff]

Probably with wire if that is what you are asking...lol...

 

[gmanauseal]

Please read the spec of your amp and what power output, like 600 watt to 1 ohm or 8 ohm.....
What ohm are your speaker, make sure you check is it a Dual 4 ohm or dual two ohm?

 

[civic99coupe]

We need the specs of your amp and subs.Most importantly impedance and RMS wattage.

 

[Pathos]

Amplifier Output Details 300.0 Watt - 4.0 Ohm - 1.0 channel(s) , 600.0 Watt - 2.0 Ohm - 1.0 channel(s)

Subs
4 Ohms
Single voice coil.

 

[Pathos]

Is there anyway to wire these to a 2 ohm load?

Or is it only 4 ohm and 1 ohm.
And i dont quite know if my amp can work with a 1ohm load. It doesnt say.

 

[TiiM iiS l3eAsT]

use this

http://www.the12volt.com/caraudio/woofer_configurations.asp

 

[civic99coupe]

Your subs are single voice coil, you can either wire them into an 8ohm load or a 2 ohm load. To obtain the 2 ohm load, connect all the positive ends together and likewise all the negative ends. This is called wiring in parallel.

 

[dtgrowl]

Probably with wire if that is what you are asking...lol...