lower tie bar Q.

[lotz6996]

does anyone have a rear lower tie bar. either a beaks or one like it. if so could you send me a picture of the end and the measurenments on it. i have more time than money and may have just the right scrap metal lying around to scratch make one for my car.

 

[oddeb707]

What do you consider the end of the tie bar? The piece that mounts to the sub frame?

 

[lotz6996]

side view. rotated 90 degrees from what you would see from the back.

 

[CHILD]

I dont have any measurements of it, but here's my carbing lower tie bar.

 

[CHILD]

i believe the beaks bar has a 90 degree piece of metal attached to the bar and uses the upper portion to bolt to the subframe

 

[lotz6996]

^^^ thanks man, i forgot about that style, that would be cake.

 

[oddeb707]

Can't find any more.

 

[lotz6996]

Can't find any more.

what is the beaks bar made out of, (ie: angle iron, channel, square tube)? whether its alum. or steel makes me no difference. mine will be steel.

 

[oddeb707]

I think it's square tube aluminum.

 

[G-rat]

here is the best pic i have of the lower tie bar

its a squar piece of alluminum that is hollow in the center

 

[oskarsx]

Wow

 

[Esotericimage]

I think it's square tube aluminum.

 

[lotz6996]

does anyone have a measurenment from center to center on the bolts?

 

[Steven-EG8]

nice..

 

[acwood04]

How hard is the installation of a rear lower tie bar on a 2004 sedan, do I have to jack the car up and realign that bolt when I install it? I did a rear strut bar today, already got a front one, just got the tie rod to do..

 

[CHILD]

there's nothing to align when you put in a lower tie bar. remove the inner control arm bolt and replace it going through the lower tie bar first.