Sigh...

[Drfunk1155]

Okay let's get this over with.
Apline headunit connected to dual amp and subs
Installing ( trying to) subs. Two twelves.

They are bridged. To a single 560 amp.
RCA and remote are connected to headunit already.
4 guage is hooked up with fuse to new battery in trunk.

One sub turns on. But it barely hits at all.
I know they work fine( just unhooked them from brothers gsr)
same wires everything.



Ground wire is connected to non painted chassis bolt.

All wires are snug.

 

[XeroReboot]

Okay let's get this over with.
Apline headunit connected to dual amp and subs
Installing ( trying to) subs. Two twelves.

They are bridged. To a single 560 amp.
RCA and remote are connected to headunit already.
4 guage is hooked up with fuse to new battery in trunk.

One sub turns on. But it barely hits at all.
I know they work fine( just unhooked them from brothers gsr)
same wires everything.



Ground wire is connected to non painted chassis bolt.

All wires are snug.

May sound stupid, but if your deck has seperate bass controls, are they properly set up and turned up?

 

[lethal6]

Just a quick note of advise. You might get a better response if you title the thread correctly. Might help to put your question in the title instead of one word. A LOT of helpful people just overlook them when they aren't descriptive.

About your problem, I would make sure the wires are hooked inside the box. Might have come loose when moving it. I would also check the settings on both the amp and the deck to see if they are set up right. The settings on the deck might even be turned off.