1994 accord lip on EG8
- Thread starter TeeJay
- Start date
L.D.Forget
New Member
i havent done it, but if the shape is different, a heat gun will be your best friend.
What kind of trouble are you running into?
Well I just wanted to know what he did to the lip to make it fit. The front part of the lip fits pretty well, except for a part on the front where I may need to cut so I can get it to fit better. The sides are just a little too long, and they stick out a bit.
heatgun, sawzall, sandpaper and zipties
somejaykid
i'm a mod now
Registered VIP
Registered OG
5+ Year Member
10+ Year Member
15+ Year Member
20+ Year Member
post pics when your done op i wanna see this
Sorry about the late upload guys, something was wrong with my photobucket. But here is a picture of the lip.
The only problems im running into is whether or not I should cut the sides a little bit so its equal to the side of the bumper. Right now its sticking out towards the tire. Also, there is a part in the middle of the lip where i think i need to cut so the lip goes flat onto the bumper. Sorry for being difficult, im new to this stuff. Lol thanks for your help guys!
The only problems im running into is whether or not I should cut the sides a little bit so its equal to the side of the bumper. Right now its sticking out towards the tire. Also, there is a part in the middle of the lip where i think i need to cut so the lip goes flat onto the bumper. Sorry for being difficult, im new to this stuff. Lol thanks for your help guys!
Sorry about the late upload guys, something was wrong with my photobucket. But here is a picture of the lip.
The only problems im running into is whether or not I should cut the sides a little bit so its equal to the side of the bumper. Right now its sticking out towards the tire. Also, there is a part in the middle of the lip where i think i need to cut so the lip goes flat onto the bumper. Sorry for being difficult, im new to this stuff. Lol thanks for your help guys!
The only problems im running into is whether or not I should cut the sides a little bit so its equal to the side of the bumper. Right now its sticking out towards the tire. Also, there is a part in the middle of the lip where i think i need to cut so the lip goes flat onto the bumper. Sorry for being difficult, im new to this stuff. Lol thanks for your help guys!
New Vega
HondArmy
It's easy! just start in the middle with it centered. i notched the front bumper and used the clips the lip comes with to bolt the centers in. then slowly work your way down the side by putting the lip where u want it and drilling it in place using self tapping screws till you get to the end. you'll have to cut it off with a saw. i used a fine tooth saw. i mounted the ends of the lip with the factory clips as well. should be easy from there. just put it on jack stands so its easier to have the car up a ways. hope this helps! deff post pics when ur done i wanna c that
Oh haha thanks! Did you cut anything in the middle?
New Vega
HondArmy
no sir. just the ends