injectors don't fit...

[Ceros]

So my new injectors won't fit. I'm doing a d16y8 turbo and also auto to manual. Can anyone help me out? The seals seem to fit but the seal on the new injectors don't fit in, and I push them in pretty hard too... wtf?

They're 450cc dsm injectors. Do I need different injectors?

Here's a pic of the injectors side by side, stock on left, 450cc dsm's on the right:

the injector spot:

 

[Ceros]

May have just found the answer myself. Do I need this?

http://www.homemadeturbo.com/tech_projects/dsm_injectors/

 

[XpL0d3r]

Hmm.. I remember my old DSM injectors fit fine, I had blue tops though. The only thing about those was that the o-rings kept breaking.

 

[2slo4u]

You have to dremel(sand down, I used a dremel with a sand paper top) the Inside of your stock o-rings to use on the 450cc Injectors. Just take a little bit off at a time until the 450cc's fit snug in your stock injector's o-ring

 

[Blood_Shot]

You have to grind out the oring if I remember rightm the fat one not the one on the very end

 

[XpL0d3r]

You have to dremel(sand down, I used a dremel with a sand paper top) the Inside of your stock o-rings to use on the 450cc Injectors. Just take a little bit off at a time until the 450cc's fit snug in your stock injector's o-ring

s*** you're right I forgot I did that too lol. good call. Iiiiiiiiiiiiiiii'm dumbbbbb.

 

[Blood_Shot]

You have to dremel(sand down, I used a dremel with a sand paper top) the Inside of your stock o-rings to use on the 450cc Injectors. Just take a little bit off at a time until the 450cc's fit snug in your stock injector's o-ring

bah got me by a minute, if I hadnt picked picked my nose

 

[XpL0d3r]

bah got me by a minute, if I hadnt picked picked my nose

 

[Ceros]

Sweet, so I just need to dremel out the holes a tiny bit, sweet. Any wiring issues I need to worry about or just that?

 

[2slo4u]

well you'll have to wire up the resistor box and you need obd1 clips

 

[Ceros]

I'm thinking it would just be best to get new injectors then...

 

[2slo4u]

well no matter what you'll need obd1 injector clips and depending on the kind of injectors you get..you might need that resistor box as well

 

[Ceros]

uggghhhh....that's annoying... : /

 

[Blood_Shot]

is it low impedence that we dont need the resistor?

 

[2slo4u]

is it low impedence that we dont need the resistor?

saturated needs no box
peak and hold you do