This is "MY BUILD" INSPIRATION

[mylovehx]

Shoulda never put them on lol

 

[203CT]

The back is fine because of the 195/60 but the front is a 195/55 so the gap is bigger and it looks off. There's at least 2.5" of gap. I put my whole foot between the fender and tire.

 

[JeffBel]

Ddddddddd-drop it low gurl

 

[203CT]

^lol

 

[203CT]

A few quick flicks I took this morning

My paint is so faded its ugly so I went and picked up some of this

I wash the car and clay bar about 30% of the car and just like a light switch it starts pouring rain. Man does clay work good. All the deep dirt and surface contaminants come right out. Amazing to see all the dirt that was left over after washing it.

I also picked up some of this stuff to try and clean up the meshies. Ill let you know how it goes.

 

[ChaddiBJ8]

aaaaaahhh snap!!!

 

[203CT]

The car definitely was in need of a wash and wax. Ill have pictures tomorrow it's to dark to take any now.

 

[mylovehx]

I've always wanted to do the clay bar. Looks good bro!

 

[young_]

I've always wanted to do the clay bar. Looks good bro!

Same


Sent from my iPhone using Tapatalk

 

[203CT]

Do it. Just when you think your cars clean go over it with clay and watch how much dirt comes off.

 

[203CT]

Some updated pics

 

[ChaddiBJ8]

looking good man. couldnt wait until tomorrow huh.

 

[203CT]

looking good man. couldnt wait until tomorrow huh.

Lol I had to take a picture while I was in some good light. And yea I couldn't wait lol here's some more

Lil guy my girl gave me before she left for school. He's rock'in her school shirt.

 

[JeffBel]

Drop it damnit!

 

[203CT]

Drop it damnit!

Lol in time man in time

 

[203CT]

Well I attempted to roll my rear fender using the baseball bat method and a hair dryer. I achieved a small roll along with some chipped paint lol. I guess it's just to cold outside the little hair dryer couldn't get the job done. I also notice my car sags a little on the driver side but idc coils can fix that issue.

I also attempted to fix the dent you see in the pictures. I was able to get some of the dent popped back out but some areas I couldn't fix.

 

[mylovehx]

I used a paint heat gun. s**t gets hot hot hot unlike your sissy hair gun
For the rears I had to hammer and rubber mallet that s**t!

 

[203CT]

Adjustment time. I never did this when I put the head back together. I started to get a tick so I thought it was time.

 

[203CT]

I used a paint heat gun. s**t gets hot hot hot unlike your sissy hair gun
For the rears I had to hammer and rubber mallet that s**t!

I'm going to have someone do mines if I can't find a heat gun

 

[CHILD]

I didn't use heat of any sort when I did mine. Only rubber mallet and a small ball peen hammer.