Picture didnt load for some reason...
Turbo Rotary Mazda Minitruck Build
- Thread starter mymmeryloss
- Start date
^^
Sent from my SGH-T999 using Tapatalk 2
Well there will only be a video if Jeff hurries and brings me a go pro.
I have been talking to Chris Ludwig from Ludwig Motorsports about an engine rebuild and streetport on this engine.
Hoping to have it rebuilt by xmas!
Thats the plan homie
would it be possible to angle the piping so the turbo sits more towards the front of the bay? might put a lot of stress on the welds though
Thats what i was trying to do.
I might try again...
I would weld some cross bracing on it if i did that though.
Its just so damn tight and idk what im doing lol.
i say go for it, i mean if you knew what you were doing this build would probably be done by now. its the first time its being done, failure is part of progress
I think if i knew what i was doing that this build would be boring to watch and to build...
that too
Thank ya!
I dont have room for that homeskillet
Straight out the hood as planned, so when it's backfiring and throwing flames, you can see it happen right in front of your face!!!
You should drop a four-rotor in.
Cool. I just gotta make sure i get a nice stainless exhaust!
I can barely fit a 2 rotor in here. How am i supposed to fit two more..
But there is a plan for a 3 rotor in a FD chassis rx7 in the future!