What rpm do you shift at when flooring it on 1st?

[ej8_st]

Redline?

 

[92lseg]

Depends on your motor/setup an where it makes power

 

[96romaCX]

2500 Rpms, then the same in 2nd, 3rd... Then red light. Repeat.

 

[young_]

2500 Rpms, then the same in 2nd, 3rd... Then red light. Repeat.

He said when flooring it..


I shift close to redline in every gear if I'm flooring it.


Sent from my iPhone using Tapatalk

 

[cvcrcr99]

Why would you not take the car up to redline when flooring it? Otherwise, there is no reason to floor it? Question makes no sense.

 

[Puma]

Why would you not take the car up to redline when flooring it? Otherwise, there is no reason to floor it? Question makes no sense.

BC you actually start to lose power at that point. This is all dependent upon the motor too.

OP this is an extremely vague question. While it's under 6 gen, you need to stipulate what motor you're running and if you have the correct cluster for it too. I'm a prime example. While I have a DX chasis, I do not have a dx motor or cluster.

 

[cvcrcr99]

I am sure if he is asking this question, the car is stock, and he has never been on a dyno to show him this information

 

[OGstackadolla]

Stock Gs-R, I shift at 8k when I'm racing. It's not just about where you shift, but also where your rpms end up. It's a trade off. We may stop making power at 7,700 rpms +/-, but we're still making more than when we shift and drop to 6,100 +/-

 

[Jermee]

No point in going full throttle in 1st gear...I just spin...can only do 3rd gear rolls




Sent from your moms house.

 

[OGstackadolla]

No point in going full throttle in 1st gear...I just spin...can only do 3rd gear rolls

Even on slick?

 

[Jermee]

I doubt id spin on slicks. Haven't bought them because I don't really race much. Just a car ill take out of the garage for shows and meets. With the occasional race with a "f*cking mustang".




Sent from your moms house.

 

[OGstackadolla]

Yee. Those hatches go hard. I'm looking into possibly doing a EgK. A couple of my teammates run k swapped Eg's and they do really well on the track

 

[95coupeWI]

9k, need slicks. Spins through every gear..

 

[boostin22]

Redline all the gears!!

 

[96romaCX]

He said when flooring it..


I shift close to redline in every gear if I'm flooring it.


Sent from my iPhone using Tapatalk

I know what he said I was just being a smarty :p

 

[Jermee]

Yee. Those hatches go hard. I'm looking into possibly doing a EgK. A couple of my teammates run k swapped Eg's and they do really well on the track

Lol my egk is a little bit different. Not what your thinking.




Sent from your moms house.

 

[xxBLOOD88SHOTxx]

6k for me

 

[Doubletap]

I remember riding with a friend of mine in his K20 swapped EM1. One problem though, his motor went BOOM as soon as he redline shifted into 3rd.

 

[ej8_st]

guy who said i was obviously talkin about stock. smart.

 

[OGstackadolla]

guy who said i was obviously talkin about stock. smart.

Wtf are you talking about? I assume your question has been answered.