New to clubcivic

[OneFastGSR]

Hey guys just registered on clubcivic. I'm a member on clubintegra same username. Thought i'd register here since I got a civic. I made a members ride thread for it already and this is the link. http://www.clubcivic.com/board/showthread.php?t=222272 It's a 92 civic hatchback stock motor little suspension/exterior/interior mods.

Also do you guys think 16" rims are to big for a civic? I swapped them out today to see what it looks like. I put some spare enkei RP01 16" +38 offset wheels on it. Here's some pics. I think they're just alittle bit too big and maybe stick to 15's for civics.

Before:

After:

 

[96 DX Hatch]

16's are the biggest one should go on a Civic.

Nice GSR, still miss both of mine

 

[OneFastGSR]

I personally think I should stick to 15s with the civic and put 16s back on a teg lol. The gsr beside the civic is a k20 type s 6 speed swap and the gsr in the background is a built b18c1 turbo. About to pull the motor about the turbo gsr and redo the bottom end with new bearings and rings, upgrade the wrist pins while i'm there

 

[cvcrcr99]

16's are just slightly too big IMO, but they dont look bad. I am more of a fan of 15's on these cars though.

 

[AlaskaB16]

I personally think I should stick to 15s with the civic and put 16s back on a teg lol. The gsr beside the civic is a k20 type s 6 speed swap and the gsr in the background is a built b18c1 turbo. About to pull the motor about the turbo gsr and redo the bottom end with new bearings and rings, upgrade the wrist pins while i'm there

Pics of the K20 swap! I have a K20 6speed sitting in my garage right now. I'm torn on what car to put it in though.

 

[95coupeWI]

The wagon for sure^

 

[TokyoSkies]

Pics of the K20 swap! I have a K20 6speed sitting in my garage right now. I'm torn on what car to put it in though.

My car!

I'd stick with 15's myself, OP. I think they look cleaner. I was going to go with 16's on mine, but have since decided to stick with 15's, and go with a slightly bigger tire since I'm not slamming it. Should fill the wheel well nicely.

 

[AlaskaB16]

My car! .

You had your chance hippy sauce! You could have it for a grand and be out pwning n00bs right now!

 

[TokyoSkies]

You had your chance hippy sauce! You could have it for a grand and be out pwning n00bs right now!

I know, I know. Who knows what will happen in the future? I just can't put it in this EJ8, not without another daily.

 

[xxBLOOD88SHOTxx]

Where in AR are you?

 

[crash!]

I like silver EGs. I like the unpainted door striping too.

 

[OneFastGSR]

Pics of the K20 swap! I have a K20 6speed sitting in my garage right now. I'm torn on what car to put it in though.

Where in AR are you?

Cabot

I like silver EGs. I like the unpainted door striping too.

I agree with the unpainted door moldings lol

I definately need some 15" enkei RPF1's on this thing! Would look good

 

[crash!]

 

[TokyoSkies]

Cabot



I agree with the unpainted door moldings lol

I definately need some 15" enkei RPF1's on this thing! Would look good

that's purdy

 

[AlaskaB16]

Lord have mercy...

 

[OneFastGSR]

Lol here's alittle bit of b series action from the integra in the back. It's darton sleeved, cp pistons, all that good junk, garrett 60 trim turbo. Laugh at the dump tube all you want hahaha It's going to get remade later after I rebuild the motor. It isn't blown or anything, Runs and drives but the main bearing clearances are too loose now and oil pressure is alittle lower than I want so going to pull the motor.