90 integra clutch

[brilla46]

So I have a question I have a 90 integra and I need a new clutch and I'm not sure which one to get since there is a couple cable trans made I know the one I have has a bigger shaft can anyone point me to the the right clutch to buy

Sent from my VS995 using Tapatalk

 

[HeX]

Uhhh, try researching it on any number of parts websites or an Integra forum for previously discussed suggestions.

 

[brilla46]

I have searched the integra forum and made a thread but have not had any help

Sent from my VS995 using Tapatalk

 

[HeX]

I have searched the integra forum and made a thread but have not had any help

Sent from my VS995 using Tapatalk

Are you sure you posted in the correction? You didn't do so here which is why I moved it. For what its worth, writing clearly would likely encourage helpful attention.

Either way, finding the correct clutch is an easy process.

 

[XpL0d3r]

@brilla46 Best option is to figure out which motor you have by looking at the stamp on the block near where it bolts to the transmission. Assuming the transmission matches the block, look online for clutch kits based on year and engine. If you have a GS, look for GS clutch kits. RS? RS kits, etc.

I believe the clutch discs are the same between cable and hydro transmissions, but the throwout bearings are different.

 

[brilla46]

I don't know what year the trams is when I bought the car the trans was bad so I bought one and put it in and not sure what year its out of

Sent from my VS995 using Tapatalk