if i recall you and scott did some stuff that weekend to
Chaos's Christmas BuildUp
- Thread starter TiiM iiS l3eAsT
- Start date
- Status
tune this b***h
it has a good ass basemap that should keep it running....but once we start it ....it just dies.....were thinking the injectors are bad (clogged) so we ran some seafoam through it and its starts to idle but still not good enough to keep it running for long.....maybe the baseidle screw as well....idk we'll figure it out
ran some seafoam through it and it now idles but only for a couple of secs......so the injectors must be the prob....gonna run some more seafoam through it and see if it will cure the prob.....if not ill buy my friends RC 550 injectors and have my friend setup a basemap for the 550's.....
well that didnt work so im gonna try switching injectors back to stock and then running my PG7 ecu and see if it runs....
atleast until i know for sure its the injectors....then ill buy some new ones and get a new basemap for my PM6
atleast until i know for sure its the injectors....then ill buy some new ones and get a new basemap for my PM6
well we switched the fuel injectors back to stock....the map sensor back to stock.....and the ecu back to my old PG7 .....she starts up and runs just fine.....
sooo.....i know the problem is fuel injectors.....im gonna buy some new ones and then try it.....ill let you guys know if it works.....
sooo.....i know the problem is fuel injectors.....im gonna buy some new ones and then try it.....ill let you guys know if it works.....
no its wired correctly.....we checked to make sure the yellow wire was getting 5 volts......so were pretty sure its not the map sensor.....also its a 2.5 bar
hehe tell me about it.....im just glad it runs now and i can drive it again....thanks for reading though....
lol i know....ive been to lazy to put it back on.....plus it looks badass without a bumper
more pics:
do you have a filer to screen on that turbo? should put a screen on the BOV aswell, sometimes they can suck s**t back in.
id double up those hose clamps also, or bead the end of each tube, so they dont blow off
id double up those hose clamps also, or bead the end of each tube, so they dont blow off
i have a screen and a clamp on the turbo for right now until i figure how to get a filter on it.....i made sure the clamps were tight on the piping as well.....if it blows off then ill bead each tube.....for now it should be fine though
true...idk we'll see if i can get to it....ive been pretty busy lately....
just some random pics:
night pic:
night pic:
thanks bro! ^^^^^
difference between hid and brights
difference between hid and brights
- Status